OptiMill®-Uni-HPC
New generation for maximum process reliability
MAPAL presents the third generation of the solid carbide milling cutter OptiMill-Uni-HPC -optimised for automated manufacturing and high cutting performance.
-
1 / 4Configurable cutting-edge design
- Chamfer for high-level wear protection
- Radii for near-net-shape machining
- Sharp cutting edge design
-
2 / 4
Optimised geometry
- Stable machining at high infeed depths
- Very good chip formation
-
3 / 4
Newly developed cutting material
- Lower risk of tool breakage
- High degree of process reliability during dynamic machining
- High degree of ductility under impact strain
-
4 / 4
Integrated chip breaker
- Short chips that are easy to remove
The new OptiMill-Uni-HPC for machining steel, stainless steel and castings has been specially
developed for automated processes and meets the highest requirements for process reliability, stability and resistance to wear.
developed for automated processes and meets the highest requirements for process reliability, stability and resistance to wear.
The newly developed cutting material has a high ductility, reducing the risk of tool breakage.
Combined with wear-resistant coatings and optimised geometry, this results in a tool that’s ultra-reliable, even in dynamic machining.
Combined with wear-resistant coatings and optimised geometry, this results in a tool that’s ultra-reliable, even in dynamic machining.
A version with an integrated chip breaker is a new addition to the OptiMill-Uni-HPC range. It
creates short chips that are easy to remove – offering clear benefits for air cooling and high
cutting performance and enabling high infeed depths.
creates short chips that are easy to remove – offering clear benefits for air cooling and high
cutting performance and enabling high infeed depths.
Das Ergebnis: längere Maschinenlaufzeiten, weniger Überwachungsaufwand und höhere
Prozessstabilität – ideal für mannlose Schichten und automatisierte Abläufe.
Prozessstabilität – ideal für mannlose Schichten und automatisierte Abläufe.
Ab September 2025 ist der Fräser in drei Varianten verfügbar:
- Kurz ohne Spanteiler (ø 3 - 20 mm)
- Lang ohne Spanteiler (ø 3 - 25 mm)
- Lang mit Spanteiler (ø 6 - 25 mm)
MAPAL setzt damit auf gezielte Weiterentwicklung eines bewährten Konzepts – für mehr Effizienz, Prozesssicherheit und Vielseitigkeit in der modernen Zerspanung.