Bearbeitung von kleinen und großen Bohrungen
Im Werkzeug- und Formenbau gibt es eine große Bandbreite an Vollbohroperationen: Von großen Bohrungen für Führungssäulen über tiefe Bohrungen für das Kühlsystem bis hin zu hochpräzisen Bohrungen für Auswerferstifte. Für die einzelnen Fertigungsschritte bietet MAPAL ein umfassendes Portfolio an Bohr- und Reibwerkzeugen.
Werkzeugübersicht für folgende Bearbeitungsschritte:
Pilotieren
Tiefe Bohrungen für Kühlsysteme sind hauptsächlich im Bereich der Kunststoffinjektion sehr verbreitet. Um eine gute Führung für extra lange Bohrwerkzeuge zu erhalten, empfiehlt sich eine Pilotierung der Bohrungen mit entsprechend kürzeren Werkzeugen. MAPAL liefert hier nicht nur die richtigen Produkte, sondern auch den entsprechend professionellen Support, um die Ziele in Sachen Rundheit und Präzision sicherzustellen.
Da die Bohrprozesse häufig auch an schrägen Oberflächen durchgeführt werden, vermeiden Anwender mit der Pilotierung der Bohrung ein Biegen und Brechen der Werkzeuge.
Da die Bohrprozesse häufig auch an schrägen Oberflächen durchgeführt werden, vermeiden Anwender mit der Pilotierung der Bohrung ein Biegen und Brechen der Werkzeuge.
Drilling from solid
Due to the multitude of bore sizes and features, the die & mould sector offers a wide range of solid drilling tools. Tap drills, guide bores for ejector pins and partial pin holes are just a few application examples.
Deep hole drilling
Deep drilling up to 40 and 50xD is very common in the die & mould sector. This type of drilling requires specialised tools. The most common are single-lip drills, with these tools being used on special drilling machines. Solid carbide drills are a real alternative for small and medium-sized components with bore diameters of up to 12 mm. The deep hole drills are equipped with two guiding chamfers and thus ensure good guidance in the bore.
Reaming
The bores for certain pins and positions require a high degree of accuracy in terms of roundness and diameter. A final reaming process is therefore mandatory. The pre-machining of these bores must also meet the requirements of the reaming tools in order to achieve the desired results.
Decades of expertise at MAPAL means a wide range of available products that are individually selected for specific requirements.
Decades of expertise at MAPAL means a wide range of available products that are individually selected for specific requirements.
Countersinking
Each bore is usually pre-machined on the edge with a countersink. Countersinking is a simple application, but some bores have special surface quality requirements. The usual tools are made from solid carbide but also HSS. The innovative countersinks from MAPAL also offer advantages for countersinking operations through better performance and higher surface quality.